Show in New York
at the Jacob K. Javits Convention Center

Model 1830TR

FOR A QUALITY THERMOFORMING AT ECONOMIC MANUFACTURING COSTS

This new type of machine consumes 5 times less energy than conventional radian ovens and takes half floor space to produce the same piece per minute.

This machine heats, moulds, and cuts 30" wide plastic roll pieces on a maximum lengh of 18".

Considering that the mould is separed from the cutting die, the production and maintenance are less expensive and the installation is faster.

This machine comes with a plug assist press that moves during the indexing time if required.
Therm@form 1830TR

FOR YOUR APPLICATIONS WITH
PVC, PET, ABS, PS, PC, PE, acrylic, etc.

GENERAL SPECIFICATIONS

  • Multi zones contact heating platens
  • Servo motor indexing (no chain)
  • Pneumatic mould table (capacity of 300 lbs)
  • Pneumatic plug assist table (capacity of 300 lbs)
  • Computerised with easy-teach mode and 32 formulas
  • Hydraulic 75 tons trimming press
  • Configurable 16" stack take off station
TECHNICAL SPECIFICATIONS
Dimensions (L x D x H)
20" x 68" x 99"
Frame size*
17" X 29"
Weight
3800 lbs
Power Requirements
CAN: 600 V / 3 PH / 10 A
USA: 480 V / 3 PH / 15 A
Air consumption
1.8 gal. par cycle @ 100 PSI
Frame Height
42"
Heating zones
8
Heating Surface
18" X 30"
Oven Power
2,5 kW
Vacuum tank (40 gal.)
1
Molding temperature controller
7.5 tons
Material width
from 5" to 31"
Material roll diameter
up to 28"
Positive forming
2.5" maximum
Knife length
270" maximum
Material thickness range
0.006" - 0.040"
Cycles per minute
18 maximum
*Other size available
 

Top

(Home) ( Consultations) (Products) (Information) (R&D) (E-mail)

© 1999-2005 - All Rights Reserved, Actif Industriel Inc.